+91-80-23721315
info@skit.org.in
Title      : Design of Machine Elements-II
Subject      : Design of Machine Elements - II
copyright © 2020   : Dr AMARDEEPAK M
Author      : Dr AMARDEEPAK M
Publisher      : Cambridge Institute of Technology North Campus
Chapters/Pages      : 8/205
Total Price      : Rs.      : 99
 
 
To Purchase, select the individual chapter(s) or click "Select all" for the complete book.

Please scroll down to view chapter(s).
Chapters
     
MODULE -1 (CURVED BEAMS) Total views (0)  
Stresses in curved beams of standard cross sections used in crane hook, punching presses & clamps
Pages: 8
Price: Rs 0   
 
MODULE -3(b) Spur & Helical gears Total views (1)  
Spur Gears: Definitions, stresses in gear tooth: Lewis equation and form factor, design for strength, dynamic load and wear. Helical Gears: Definitions, transverse and normal module, formative number of teeth, design based on strength, dynamic load and wear.
Pages: 52
Price: Rs 26   
 
MODULE-3c BEVEL GEARS Total views (0)  
Bevel Gears: Definitions, formative number of teeth, design based on strength, dynamic load and wear.
Pages: 14
Price: Rs 7   
 
MODULE -4a WORM GEARS Total views (0)  
Worm Gears:Definitions, types of worm and worm gears, and materials for worm and worm wheel. Design based on strength, dynamic, wear loads and efficiency of worm gear drives.
Pages: 24
Price: Rs 12   
 
MODULE-5a LUBRICATION AND BEARINGS Total views (1)  
Lubrication and Bearings:Lubricants and their properties, bearing materials and properties;mechanisms of lubrication,hydrodynamic lubrication, pressure development in oil film, bearing modulus, coefficient of friction, minimum oil film thickness, heat generated, and heat dissipated. Numericalexamplesonhydrodynamicjournal and thrust bearing design.
Pages: 19
Price: Rs 9.5   
 
MODULE-2a Belt Rope & Chain drives (Theory) Total views (0)  
Belts: Materials of construction of flat and V belts, power rating of belts,concept of slip and creep, initial tension, effect of centrifugal tension, maximum power condition. Selection of flat and V belts-length & cross section from manufacturers’ catalogues. Construction and application of timing belts. Wire ropes:Construction of wire ropes, stresses in wire ropes, and selection of wire ro ......
Pages: 18
Price: Rs 9   
 
MODULE-2b BELT ROPE & CHAIN DRIVES (NUMERICALS) Total views (0)  
Numericals in Belt rope and chain drives.
Pages: 30
Price: Rs 15   
 
MODULE-2c Design of Springs Total views (0)  
Springs:Types of springs, spring materials, stresses in helical coil springs of circular and non-circular cross sections. Tension and compression springs, concentric springs;springs under fluctuating loads. Leaf Springs: Stresses in leaf springs,equalized stresses, and nipping of leaf springs.
Pages: 40
Price: Rs 20